Skip Navigation to main content U.S. Department of Energy Energy Efficiency and Renewable Energy
Bringing you a prosperous future where energy is clean, abundant, reliable, and affordable
Energy Savers
Your HomeYour VehicleYour WorkplaceRebates, Tax Credits and FinancingProducts and ServicesRenewable EnergyInformation ResourcesHome
Your Home
Apartments Appliances and Electronics Designing and Remodeling Electricity Energy Assessments Insulation and Air Sealing Landscaping Lighting and Daylighting Space Heating and Cooling Water Heating Water Heater Selection Energy-Efficient Water Heating Drain-Water Heat Recovery Hot Water Use Hot Water Pipe Insulation Storage Tank Insulation Water Temperature Heat Traps Timers Meter Reading Swimming Pool Heating Windows, Doors and Skylights
Learn More

Financing & Incentives

Find Federal Tax Credits for Energy Efficiency
Energy Savers

Find Appliance Rebates in Your State
Bookmark and Share Printable Version

Installing an Insulation Blanket on an Electric Storage Water Heater

Here are step-by-step instructions for installing an insulation blanket on an electric storage water heater. If the insulation blanket you've purchased comes with instructions, read and follow those.

  1. Illustration showing a water heater with insulation on the top and cut to fit around the piping. The cuts have been taped closed, and the corners of the insulation have been folded down and taped to the sides of the tank.Cut the tank top insulation to fit around the piping in the top of the tank. Tape the cut section closed after the top has been installed.

  2. Fold the corners of the tank top insulation down and tape to the sides of the tank.

  3. Illustration of a water tank covered by an insulation blanket secured by two belts.Position the insulating blanket around the circumference of the tank. For ease of installation, position the blanket so that the ends do not come together over the access panels in the side of the tank. Some tanks have only one access panel.

  4. Secure the blanket in place with the belts provided. Position the belts so they do not go over the access panels. Belts should fit snugly over the blanket but not compress it more than 15%–20% of its thickness. The installation is easier with two people. If working alone, use tape to hold the blanket to the top until you get the belts into position.

  5. If your water heater has the temperature/pressure relief valve and the overflow pipe on the side of the tank instead of on the top, install the blanket so these items are outside of the blanket. Depending on the piping arrangement and location, you may need to compress (or even cut) the blanket.

  6. Illustration of a water tank covered by an insulation blanket secured by two belts. At the bottom of the tank, an x-shaped cut has been made in the insulation blanket over the access panel.Locate the four corners of the access panel(s). Make an x-shaped cut in the insulating blanket from corner to corner of each access panel.

  7. Illustration of a water tank covered by an insulation blanket secured by two belts. The triangular flaps created by the x-shaped cuts have been folded under the insulation to expose the access panel.Fold the triangular flaps produced by the cuts underneath the insulating blanket. Repeat steps 6 and 7 for the rating/instruction plate.

Note: The blanket must not be installed on a leaking tank. If your tank leaks, you need a new water heater.

Don't set the thermostat above 130ºF. The wiring may overheat.